Re: Paste Wax Question...Wiley...
Wiley Horne--So. Calif.
Hello George,
For cherry and maple, I generally use Jeff Jewitt's method of lightly oil with boiled linseed oil, followed by wiped-on shellac (super blonde, dewaxed flakes). Shellac made up with denatured alcohol straight from the Borg. The shellac is laid on in multiple thin coats, say l-lb cut or a little less. Then de-nibbed and deglossed by rubbing out with 3/0 or 4/0 steel wool and wax. I've used different waxes, usually BriWax clear or Mylands. This is done out of doors and I have not had the problems others cite, but then we have a quite dry climate here. That's for exterior surfaces. For rubbing out, the wax needs a lubricant, so I like a softer wax which self-lubricates. Then as time goes on, use a hard wax like the Orange Wax cited above for maintenance. If a hard wax is used when the piece is made for rubbing out, add a lubricant like mineral spirits.
[Variation which I once used on maple appearance surfaces......initial surface prep. is sanded-in BLO, heavily applied, with multiple sandings (100g, 220g, 320g), until the wood just won't accept any more oil. You pour on the BLO and start sanding it right in; sand til oil has disappeared; wait a couple hours or til next day and do again, this time with next finer sandpaper grade; quit after 320 or 400. This initial prep. fills the pores, and leaves oil about 1/16" deep in the wood. Then apply shellac and rub out with steel wool/wax. This yields an incredibly deep, smooth to touch, with satiny gloss. It's more work than I ever want to do anymore, but does yield a wonderful surface.]
For drawer interiors, I omit the oil, and apply the shellac in less than 1-lb cut, a few coats, right over the dry wood. Then denib with 4/0 steel wool or a very flexible scraper (LV sells these as 'super thin, superhard'--they're great). Nowadays, I will then wax with the Orange Wax or equal. In the past, I have lightly waxed with whatever I had (generally with petroleum distillates), with no ill-effect after airing. Interior drawer and case parts like drawer sides, runners, kickers, everything--are finished with shellac and rubbed-out wax, so there is minimum friction and drawers glide smoothly and evenly, no matter where they're pushed.
Here's Jeff Jewitt's articles on shellac finishing:
http://www.homesteadfinishingproducts.com/htdocs/shellac.htm
http://www.homesteadfinishingproducts.com/htdocs/padshellac2.htm
Caveat 1: I really don't know jack about finishing. Just start with whatever Jeff Jewitt says, or what I pick on online or in books, and make up the parts that aren't explained in the original sources.
Caveat 2: Jeff Jewitt says final prep. before finish is 180-220 sanding. Bill Tindall and most every professional I've ever read swear by this as well (and get great results). I don't do this. On flat surfaces, I finish over a planed surface or filed end-grain. Or sometimes scraped with the super-thin scraper mentioned above. My theory--which I can't defend technically, it's just what appeals to me--is to stay as close as possible to the clarity of the planed or filed or scraped surface. Or maybe I just don't trust my sanding.
Bill Tindall published a few months ago on these pages, some cherry finishing he did, which had excellent clarity and even color. He supplied details of the procedure.
Wiley