New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Chest or cabinet?

Posts

Re: Chest or cabinet?

#26

Follow up question

Ron in Kokomo

Are you concerned at all about the dust/ rust issue?

Ron

Re: Chest or cabinet?

#27

Re: Follow up question

TomD

Rust has been a big problem in my shop which is ground level and dry. Humid air, only a day or two a year can cause widespread condensation on surfaces in the shop, and those that are prone to rust, mainly cast iron and some tubing stock can really get wrecked.

Just this spring, I set up a window fan to pull air into the main shop from where it gets hot in the attic area, and this has proved really effective getting the temperature above the dew point at low cost.

Re: Chest or cabinet?

#28

rust is a real problem in the summer

Bruce, a MN Galoot

most of my hand tools are held in a vertical position, so not much dust stays on them.

However, power tools are another situation. Any sawdust that stays on them attracts moisture, so bandsaw and tablesaw need to be kept clean (which is not in my nature) or they instantly rust. DP, same thing. Chop saw table is aluminum, so not a problem.

Re: Chest or cabinet?

#29

Re: rust is a real problem in the summer

roger lance

Bruce....good point....it is that time of year to give everything a good cleaning and wax down those surfaces....plug in the dehumidifier and be watchful....

Re: Chest or cabinet?

#30

Re: Follow up question

Derek Cohen (in Perth, Australia)

Hi Ron

Perth is very dry for most of the year, and the temps do not drop too far. I'm not sure whether it is global warming or what but it does seem as though humid conditions have increased. Mostly I have experienced little rust issues, but now I am being more diligent about using Camellia Oil and a surface protectant on cast iron machines. Keeping tools in pine cabinets helps absorb some of the moisture in the air.

Regards from Perth

Derek

Re: Chest or cabinet?

#31

Or the winter

Bill Houghton, Sebastopol, CA

Here on California's North Coast, winter is our damp time (well, most winters; we've had some droughty years recently; I'll take staving off rust, thank you, over no rain).

Re: Chest or cabinet?

#32

Re: Chest or cabinet?

Brian Anderson Gunsmith

Couple thoughts on why "modern" chests would be heavier.

1. many cabinetmakers would make them out of more exotic/heavier woods.

older chests tended to be made of pine or similar.

2. many bench planes (and other tools I suppose) may well be metal vs wood.

3. "modern" cabinetmakers may have more "gadgets" and multiple variations of tools.

Re: Chest or cabinet?

#33

Re: Chest or cabinet?

Charles

Yep, right on all points I think.