New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Progress and question

Posts

Re: Progress and question

#26

Not reacting often requires attention

Bill Houghton, Sebastopol, CA

Many of us get caught up in the emotion that's floating around - anyone who's been in a relationship for a long time knows about the fights that seem to come from nowhere because one party gets a little emotional, and the parties then run each other up.

Not much for it but deep breaths and looking at the post before hitting "submit."

Re: Progress and question

#27

Re: How to machine wider than 8"

TomD

Todd, I think the usual formula is all the same, or the middle one slightly wider. If the joints are well done, as seems reasonable based on progress to date, it can be impossible to spot the middle board. It can be discerned, but not necesarilly seen in normal observation. This doesn't always work that great if the thrid board strongly contrasts at the joint line.

I would also go a long way to use two boards only if I had them to use. Are you restricted by the size of your jointer (normally the 8" tool)? You can use the rebbating function to cut away excess material on one or both edges, then run the raised section over the 8" of remaining board. This gives you a true central or one edge of the board. Then you can run the board through your planer on the true surface, then flip and do the other side. So by this means you can easily get up to the 12" capacity of your basic portable planer if that is where we are.

Re: Progress and question

#28

The value of these discussions

Bill Tindall

"Never occurred to me" ........fill in the blank.

For some that are professionals, or functionally so, their techniques have served them well for many years and there would be little reason to change what works reliably and at least for them, quickly. But, the majority of the people that follow these discussions haven't settled on their "best" way of doing this or that, and they may not have the skill or experience to implement some ways of doing things (I can't do pins first, for example). For this audience, discussions of different ways of how to do some woodworking operation, justified by the reasons why it was chosen among the possibilities, are of great value in perfecting our skills.

I looked at other Forums and concluded that the depth of experience on this Forum vastly exceeds any other. To have access to someone knowledgeable of English trade practices, or another who seems to have experience with every tool made by man, to name but two of dozens of examples, is a resource unequaled. I hope everyone continues to be a passionate advocate of their knowledge and experience.

Re: Progress and question

#29

Amen !