New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

planing diversity

Posts

Re: planing diversity

#51

Re: two quotes that expain so much

David Weaver

Whatever surface is meeting the edge on the opposite side of the bevel should have the same level of polish as the bevel when you're done honing the iron.

If you have created significant wear on the back of an iron (you can see it if the edge had a good polish to begin with, especially on a high carbon iron), then whatever you need to do to remove the wear and come back to a polished surface is fine.

You will see a lot of discussions about trick steels versus the old plain carbon steels and their virtues. In my experience, an aggressive cutting finish stone is fine for the removal of scratches on the back of an iron as long as the pressure when polishing is on or near the area where you want to remove the wear and bring back to a polished edge.

It isn't so important how you accomplish polish all the way to the edge on an iron that needs to be sharp and needs to provide a nice finished surface, it's just important that you do it and that the underlying edge geometry is nice.

I almost always use a shapton 15k stone as the final stone on smoothers. I can bring the edge back to a polish with it, and if the iron is something rubbery like an M2 high speed steel iron, I will use a ruler trick or a more aggressive abrasive, like diamonds or chromium oxide.

If you can't see what you're doing at the very edge, buy a cheap jeweler's loupe to confirm what you're doing. The higher the magnification, the better.