New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

CPM 3V for bits?

Posts

Re: CPM 3V for bits?

#51

Re: An alternative, at least short-term...

Pam Niedermayer - Austin, TX

Thanks, David, I'll keep an eye out for a belt sander. I've got a disk sander on the table saw, so will see how far I get. It's proved to be very handy.

I've also got a couple of saw frames and a few blades.

Pam

Re: CPM 3V for bits?

#52

Re: And

Pam Niedermayer - Austin, TX

Thanks, Tom. You're right, I don't relish adding noise and mayhem to the shop. I've wondered what those hand held band saws were for.

Are you saying O1 doesn't have to be forged? Or heat treated?

Pam

Re: CPM 3V for bits?

#53

I mean the initial stupidity

Bill Houghton, Sebastopol, CA

not the response to it. All it takes is not thinking for a minute.

Re: CPM 3V for bits?

#54

Re: I mean the initial stupidity

Bob Hackett

We all have the right to be stupid.Unfortunately there`s very little to keep some of us from abusing that right.

Re: CPM 3V for bits?

#56

Just the Darwinian imperative

Bill Houghton, Sebastopol, CA

and that applies only to extreme abuses of the right to stupidity.

Re: CPM 3V for bits?

#57

Visit your local factory or shipyard

Bob Hackett

Chances are you`ll be able to see several generations of stupidity at work,sometimes on the same project.