Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Hinge Morticing

Posts

Re: Hinge Morticing

#51

... Hit the enter button too early.

Andrew F in Australia

>Not having the greatest day here.

The end of the email meant to say:

THanks again for your input and wisdom/advice.

CHeers,

Andrew

Re: Hinge Morticing

#52

Re: Hinge Morticing

ThomD

>Great series of photos. Like a quality book. Only thing I do differently is probably less relief cutting before going to the veritas plane. It's a very nice plane for this sort of thing.

Re: Hinge Morticing

#53

Re: Mortising of hinges - Pam and Derek response

Pam Niedermayer, Austin, TX

>Thanks, Richard, very good drawings. It sounds like what you're doing is setting the hinge into the stile, with little to no projection beyond the surface, only way I can figure that 180� opening.

Pam

Re: Hinge Morticing

#54

Re: Mortising of hinges - Pam and Derek response

Sgian Dubh

>Pam, you can adjust the projection of the knuckle from the door face/carcase edge according to the throw you require for the door to bypass a moulding or other feature, remembering, of course, that a door's front face is normally inset from the front edge of the carcass by about 1- 1.5 mm; about 1/16" or so.

The other factor to note, as I mentioned earlier, is that offsetting the hinge from the centre line that exists between the hinge stile and the inside carcass face also offsets the pivot point, and this affects the throw of the door, ie, how the edges and faces of the door enter and exit the opening. The only way to see it without experimenting on the real thing is using card as I described earlier, or you can draw it out using orthographic techniques such as AutoCAD, or a drawing board and a T square and so on.

Ta for the kind words re my doodle by the by. Slainte.

Re: Hinge Morticing

#55

Re: Mortising of hinges - Pam and Derek response

Pam Niedermayer, Austin, TX

>Yes, I plan to experiment. I've learned a lot in this thread, glad Derek brought it up.

Pam

Re: Hinge Morticing

#56

Old Practical Skill Exercise photos of both hinges

Andrew F in Australia

>Disclaimer - it's not mine - there's some errors on this that I wouldn't let through.

Hi All,

As discussed, an old practical skills exercise shows visual differences in hinge mounting. There's a hinge mounted to our convention (nb: NOT UK or US convention,) as well as a feathered hinge.

To pass this practical skill test, both hinge pins had to be aligned and set identically with respect to the door stile so the 'door' swung freely and unimpeded.

Photobucket

Hopefully, setting the jpeg size to 50kb won't affect resolution here

From front, no difference in hinge appearance

Photobucket

Feathered hinge

Photobucket Photobucket
note that the carcase side is lying flat, the door hinge leaf is pointing vertically

Butt hinge screwed onto carcase side.

PhotobucketPhotobucket

Hope that this helps out

CHeers,

Andrew F