Re: Dado planes?
Don McConnell
>Wiley,
According to Mark & Jane Rees ( in Goodman's _British Planemakers from 1700_), the earliest extant examples of dado planes are three "proto-dado" planes made by William Madox. His working dates were 1748 to 1775. They also report that the first textual mention of dado planes is a 1793 entry in the Gabriel ledger, followed by the Seaton chest inventory of 1796.
Creating dados without specialized planes can be done in a variety of ways, but I doubt the basic approach has changed all that much over the years. A fair idea of this approach can be found in David Denning's _The Art and Craft of Cabinet-Making_, first published in the 1880's, I believe. For through dados, the width of the dado is defined using a square and striking knife. The knife lines may, or may not, be turned into a V-groove with a chisel, then the waste is isolated using a saw to cut down to the depth gauge lines. This may, or may not, be done using a thin batten to guide the saw. Then the bulk of the waste can be readily removed with a chisel. If the depth of the dado needs to be uniform, the dado can be finished up with an "old woman's tooth," or a rabbet plane if you have one narrow enough.
For stopped dados, Denning indicates that the saw can be "partially" used in the above manner, the isolated waste removed with a chisel, then finish up with a "old woman's tooth" - advancing the blade a little at a time until reaching full depth, ending at the "stop." An alternative is to create a cavity, behind the "stop," using a centre bit and chisel, to provide a place for the toe of the saw to run into. The stopped dado can then be finished up as with a through one.
Denning finishes up by observing: "A special plane, called a trencher, is made for cutting cross grooves, but it is not often seen [in cabinet shops]." So, apparently, it was still common, in the late nineteenth century London cabinet shops, to create dados without specialized planes.
Don McConnell
Eureka Springs, AR