Tracing a moulding geometrically (Roubo)
Bjenk Ellefsen
>So I dusted off my geometry skills and got to work on a Cyma molding for the cupboard I am building. The molding will be done with my Mosley and Sons hollow and rounds.
In the first sections of Volume 1, Roubo gives a crash course in Geometry after saying that woodworkers don't know much about it and that it is important to know the basics. This is my first attempt following his instructions on a molding which has as much height as width (square). The next step is figuring out his instructions on tracing the Cyma (doucine) when the molding has more height.
Roubo says that we could do it by eye but it is best to know how to do them geometrically. His "mentor" and greatest influence was a geometrician. Roubo says that even though we could trace profiles by eye, "it is important to learn to do them geometrically so that we can get accustomed to bring order and truth in the composition of profiles (moldings are like the letters we use in writing: their combination forms an infinity of words and diversity of languages) so that we do not expose ourselves to the faults of Gothic architects who are moving away from the perfect and regular forms the Greeks and Romans gave to their profiles and moldings. They (goths architects) have created new profiles of bad taste that have reigned in France for too long". His words not mine!
Ironically, I believe Chippendale included many Gothic influences in his Director and you can find in the presentation page the line: "In the most fashionable taste".
So on with it (Cyma recta and reversa):
1) Trace a diagonal ie from point i to e
2) Find middle of ie and place point f
3) trace a perpendicular gh passing through point f
4) use points g and h as a swing point to trace the curves with a compas.
The reverse concave and convex curves:
extend a line from point e to a new point down to create a square with point f and use the new point as a swing base. Vice versa for point i.





