Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Sharpening with loose abrasives?

Posts

Re: Sharpening with loose abrasives?

#26

Little different model

Wiley Horne--So. Calif

>The surface of a leather strop is more like a mop than a furrowed ground. It is fibrous and stringy. And compound stringy, where the strings have strings. So what happens when the diamond paste is applied, is that the carrier sinks into the leather, gradually saturating it, while the particles are entrained along the strings. Some of the particles, maybe most of them, make it to ground. But a lot of the particles populate the strings. When you run a blade over it, the blade of course flattens the strings down into a resilient mat, and the particles on the strings abrade metal. As the strop is used more and more, some of the particles are carried away on the metal, some are driven further down to ground, and some remain entrained on the strings. There is a gradual attrition, and so the strop has to be recharged.

Same principles with 1/2-micron chromium green. It's the charge on the strings that does the work, and with use there is attrition of the cutting particles--many of them getting driven too deep to cut--and so the strop has to be recharged from time to time.

The resiliency of the leather mat is why stropping on one (with an abrasive applied, as opposed to stropping on the bare leather) will fairly quickly put a radius on the bevel, and a radius on the back too, for that matter.

Wiley

Re: Sharpening with loose abrasives?

#27

Agree

Wiley Horne--So. Calif

>Yes, cast iron seems to be about perfect. That was a good idea about the granite, by the way.

Wiley

Re: Sharpening with loose abrasives?

#28

Yeah, I was thinking of wood stropping

John in NM

>Probably because thats the only stropping block material I've ever used. Used to take fine waterstone sludge at the shop I worked for and spread it on a block of maple or cherry, since the owner gave me dirty looks if I brought in my oilstones to use ;)

Re: Sharpening with loose abrasives?

#29

"A diamond is forever" has been taken

Bill Houghton, Sebastopol, CA

>so you can't use that slogan.

Re: Sharpening with loose abrasives?

#30

But Diamonds are a girl's best friend...

Parisian, VL

>or should that be friends?

Just looking at "the Object at Hand" in the Smithsonian magazine. Carol Channing's dress from the Broadway show "Diamonds are a Girl's Best Friend" was featured. cute story.

Regards,

Victor - In Hot and Humid Houston

Re: Sharpening with loose abrasives?

#31

Re: Old Plane's

Howard Pollack

>Hi- If old planes would work would an old jointer bed or tablesaw table work too? Thanks -Howard

Re: Sharpening with loose abrasives?

#32

Re: Old Plane's

Victor Parisian

>I think that has been suggested by others. Should work just fine. (I have to ask my brother what he did with that old craftsman tablesaw.)

One of the other suggestions on one of the boards was a front disk rotor, but that would have to be ground smother than any brake shop ever dreamt about.

Most machinist supply houses sell cast iron plates (purpose evaids me for the moment) that are reasonably priced.

Someone even suggested that the replacement parts(wings) for some of those older table saws are still available at "cheap" prices. Call Sears and inquire.

victor - getting back to work

Re: Sharpening with loose abrasives?

#33

I hope so

Bill Houghton, Sebastopol, CA

>I have two tablesaw tables that I've been saving to experiment on.