Thanks, Denis... long, wordy answer
David Barnett - SW Florida
>I've already started jotting down the stuff I usually forget.
See "Belated response - a) in general, b) demo/tutorial" below.
You asked: "My question is, what do you think of mill files, such as the Nicholson Supershear or the ones sold by LV? I didn't see them mentioned."
While I was addressing the singular loss of Auriou rasps, I love files, too, but that's a whole 'nother ball o' wax, and although there are far fewer offerings than even a decade ago, there are enough still being made that I'm not really worried about an apocalyptic file famine. But I'll be glad to relate my recent experience.
Those milled-tooth files are actually made in 'flat', half-round, and, I believe, curved offset patterns, although that one may have been discontinued as I haven't seen one in years. We called them all 'aluminum floats', and I just used one on a small project; rectangular cabinet and drawer pulls of BRW and aluminum. My first set matched brushed nickel with the RW, but aluminum was requested this go 'round. They sure leave a smooth surface, with lots of shiny and somewhat dangerous curlies lying about.
As 6061 aluminum is a 'gummy' metal, it doesn't hurt to wipe on a film of lard from time to time, but only if you've not yet affixed the RW, which wouldn't do at all. I smear lard or file a lump of tallow whenever I pause to rake out debris. BTW, I suggest using a scrap of copper or bronze to rake swarf. An all-copper penny will do the trick, soon grooving itself to the tooth pattern. You can also use a brass brush, but many are too wussy for this job.
Okay, let me back up a bit. These Nicholsons are also superb on woods, and are especially well-suited to hard oily tropicals, so were a perfect choice for the pinned and epoxied bond of aluminum to RW, resulting in a cut that was flush to the touch, without dirtying or discoloring the wood, although frequent RenWaxings aided in this, as well.
Another good choice for working wood/metal combinations is the Nicholson Long Angle Lathe file, in 10", 12", or 14". These are fast cutters, similar to jewelers' F. Dick files, but in a mill pattern. They'll leave acceptable surfaces ready for final smoothing (sanding) after a bit of a learning curve. I like them on less oily woods of less intense hardness - oak, mahogany, and walnut come to mind - and, as one might surmise, they're especially facile for combo wood/metal turning Try the 8" or 10" Magicuts, too. Fast, easy to control, they'll take a polite bite on many woods and metals.
On the other hand, I'd avoid the Nicholson 'aluminum files'. They leave a too-rough surface for my taste, their main advantage being speed with less clogging than a standard mill file. In my hands, at least, they leave a somewhat chattery grooved surface on wood, and just at the worst time. You're mileage may vary, of course.
At any rate, I'm mostly dedicated to helping assuage Auriou deprivation for now, but would be glad to talk about files. As you can see, it's hard to get me to stop, heh.