Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Tipping point

Posts

Re: Tipping point

#51

Re: Tipping point

Ralph Lipeles

Maybe the rubbing should be done with powdered pumice used with a sponge or thick piece of felt. That will cut slowly and spread the load more evenly then paper.

Re: Tipping point

#52

Re: Tipping point

Jesse Cloud

On a different tangent, I know a lot of highly skilled woodworkers who send their work out for finishing. No shame in that.

If your next fix doesn't fully solve the problem. Find a good refinisher or a furniture maker who will deliver a solution.

Then move on to the next project.

Your are an incredibly skilled furniture maker and if you jumped to another hobby I would really miss seeing your work here!

Re: Tipping point

#53

Along those lines....

John in NM

The 1" felt pads for furniture legs work great for pumice/tripoli. I usually stick one to two fingers and dip in a shallow tray of oil followed by dipping in a small pile of the powder. Eventually the oil takes the sticky backing off, but it still seems to stick to your fingers some even then.

Might not want to do a large area this way, but for small projects they work great and are cheap.

Re: Tipping point

#54

Re: Second that

David Yoho

Hey Joe, there's a ulterior motive in my reasoning. Not only could I help you out but I could get to go eat at one of Michael Symon's restaurants while there. Actually, there's a couple of others too. Good luck with the clock, man.

Re: Tipping point

#55

Re: Tipping point

mdclor

Joe, how long does it take you to train one of your Goldens to heel or sit or stay? It requires a great deal of patience on your part and the effort is well worth the reward. Why should finishing be any different? You just need to find a trainer that will get you through your finishing challenges. I hear there is a great one in Cleveland if you can get him. :D Keep at it!

Re: Tipping point

#56

Re: Tipping point

don stephan

Was reading today a story about shellac finish on a complex piece. Writer said each successive coat used slightly thinner shellac so the brush marks became progressively smaller. I also remember a woodworker who said to brush on a thick coat of 2# shellac to create a build, dress runs and drips with a razor blade (using it like a card scraper) and then lightly pad over the entire area several times as needed to blend in the scraped areas.