Tipping point
joe in a Cleveland suburb
I reached the tipping point tonight on my clock. Gave up and tossed it in the garbage. I've been "woodworking" for about 20 years and still can't put a good finish on anything.
I've been trying to brush shellac on the door and panel. No matter what I do, no matter the advice I get, it looks like crap. Can't do it.
I've bought countless videos, watched countless YouTube videos, read countless WORTHLESS magazine articles, countless web articles and forum posts, and it just doesn't click for me.
I've bought so many 'best' brushes for shellac I don't know what to do with them all. I bought Everclear and on and on.
All of this best stuff ends up with the same result: lap marks, tide marks, and worst of all ridge lines from the brush. I have sanded everything down and restarted so many times it is rediculous. I'm damaging the dye that was applied.
I've been trying to get this right literally for weeks.
I've tried 2 pound cuts, 1 pound cuts, all DNA on and on. Wipe on. Pad on. Hot days. Cool days. Humid days. Dry days. A/C on. A/C off. Same results.
I won't even start on about rubbing out. I can't get that right either. Other than to say nobody ever addresses how to deal with any surface other than a flat piece of wood. What about frame and panels? How do you brush and rub out, or pad on either shellac or varnish surfaces that have rails and stiles? Corners? Anything other than a simple flat surface. I have never seen that problem adressed in a magazine article or video.
Perhaps I am too much of a perfectionist, but the finishing portion of building anything is so frustrating for me it's seems to be no longer worth it. I'm done. I don't know what else to do.
Thanks.




Well, now that Jerry has admitted to using a rattle can, I can 'fess up. I have no space/electric/safe place for a big compressor. My garage/shop also houses a gas water heater and a gas boiler, so not safe for spraying.


