Re: Contrary point of view.
TomD
I don't think you will be disappointed, though I have to say I have happily worked wood for 40+ years, and don't see the need for any of that stuff, it is mostly just gimmicks, or for that mater stuff you can add to a far smaller number of holes than having the whole dog system in the round.
A few points in favour of square holes:
1) you can install them with a saw and chisel, without needing, say, a drill press. I have 3 drill presses, etc... but in the day...
2) They are angled and can be pounded down to add downhold that isn't replicated by round dogs. Why would anyone install a round vertical hole in a directional situation. The non-directional situations develop splitting forces, and are marginal.
3), you can make your own good quality wooden dogs. I don't think that round dogs that are made of wood are nice. wood dogs are easier on blades. Square dogs work even with very little retention spring to them, because the load and retention functions can be separated. The springs on the LV dogs are kinda nasty, they aren't even all that good in metal stuff like the Tucker vise. In order to rotate they don't have a flange that holds them at level, and they are generally too short. The holes wear a lot faster, and don't wear round. Possibly not great for softwood benches.
There are other reasons like they don't develop splitting forces, or rotate. Rotation is more useful than non-rotation, but they still only rotate.
You can't have the advantages of square holes without square holes, as also applies to round holes. No law saying you can't have both. I would have a hard time seeing the advantages to the LV round system on the main dog rack, if I was having both. No law against having both.
They look like a carpenter, or a cheese maker made the bench. Cabinetmaking, is not a bout whipping out the drill.