Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Bench Dogs

Posts

Re: Bench Dogs

#26

David Barnett

(Message Deleted by Poster)


Re: Bench Dogs

#27

ditto


Re: Bench Dogs

#28

challenge accepted

Bill Tindall, E.TN.

My round dogs can be made on the lathe, which every woodworker should have, in a minute and a hole placed where ever it is needed in a minute more.

Re: Bench Dogs

#29

craigd

Re:  challenge accepted

craigd

I can make pair of square dogs in two minutes on a table saw. I leave the two "lips" at the ends and kerf out the middle (looks like a inverted U) and then saw in half for a pair.

Or I just take rectilinear stock and glue on a square tab at the top.

I saw "can" because every hole has its dog.

Re: Bench Dogs

#30

Re: A challenge to you round dog guys....

William Duffield

There's no doubt your methods will work. I've carved claw and ball feet on a bench with one metal shoulder vise and just a hand screw to hold them in place, no dogs at all. I don't find it fun to do it that way, but it can be done. An operation where non-rotating dogs are a distinct disadvantage is in carving a pie-crust table top, or many operation on any circular top. If you clamp it in two dogs, so the corners of the dogs don't dent the edge of the top, then almost half of the top is hanging out in midair in front of the bench. A better solution is two rotating dogs in your vise chop and two more rotating dogs in the bench top. This supports more of the surface and lessens the chance of leaving dings in the edge. Of course, a holdfast with a block of scrap works pretty well, too, and blocks of scrap shaped to match the table edge, placed between any dog and the work, further prevent damage to the top.