Shaker inspired Window Seat
Phil
A project I am just wrapping up: Shaker inspired window seat. Quarter-sawn cherry/cherry plywood with GF Enduro-Var finish. Yet another project added to the "I'll never do that again" list.
Knowledge You Can Build On — Est. 1998
Shaker inspired Window Seat
Phil
A project I am just wrapping up: Shaker inspired window seat. Quarter-sawn cherry/cherry plywood with GF Enduro-Var finish. Yet another project added to the "I'll never do that again" list.
There's a lot more there than a window seat....
roger lance
that's a great accomplishment!!.....wonderful looking cabinetry.....a great room.....and a great window seat!
Re: Shaker inspired Window Seat
Bill Tindall
Oh my that was a lot of acreage to finish. But it looks great.
Re: There's a lot more there than a window seat...
Phil
The cabinets are just there to support the pillows 
Re: Shaker inspired Window Seat
Phil
First project where I measured the finish in gallons, not pints. Lesson learned: stick to pints.
Re: Shaker inspired Window Seat
larry in nw ohio
Phil That is a really great job done there. If I would do something like that, it would be more of a career for me.
Larry
Re: Shaker inspired Window Seat
Chuck Kettler
Very, very nice. If you had to do it again, given what you know now, what percentage of the total time spent the first time around would you save?
Very nice
Joe in a Cleveland suburb
Looks like how I did my kitchen.
Me too, Joe
Ellis Walentine
My kitchen is cherry with flat panels and dark knobs, very similar to Phil's built-in. I'll have to take a few photos and post them, maybe as a Shop Shot. I've been holding off because we hadn't installed our finish floor until just a couple weeks ago. No excuses now.
Ellis
Re: Me too, Joe
Phil
Partial shot of my kitchen. What can I say, I like Shaker, and I'm a one trick pony.
Re: Me too, Joe
Joe in a Cleveland suburb
What did you use for panels?
I used Cherry ply and was never super happy I did.
Also, I made face frames and used hinges.
Wished I hadn't. I would rather have used Euro hinges, but back when I made them, there weren't Euro/cup hinges that would have worked with face frames- I don't think there were anyway...
I dislike the hinges so much, I would be tempted to retrofit cup hinges if I could.
Yours look nice. Nice work.
Re: Me too, Joe
Phil
Thanks. Euro-hinges throughout (did not see the need to torture myself trying to get 28 doors aligned using butt hinges). Plywood is a true 1/4" product with MDF core. These panels are glued full perimeter into the rails/stiles. Makes a nice solid door with no rattles.
Re: Shaker inspired Window Seat
Phil
A tough question to answer: I do tend to labor over details, and having labored over the basic approach once, there is some economy to be had the second time around. I've done kitchen cabinets, and I'd have to say that in a sense, this is a notch more difficult because I had to be a little more fussy on the interiors of these cabinets (all cherry everywhere, with full finish schedule). The kitchen cabs. I built were birch on the inside, I seem to recall the interiors going much quicker. I would imagine that even the 10th time you do a project like this, its still daunting.