Re: Grey Motor
Robby Wright
Charlie - That is the exact planer I have, minus the stand. I had to have purchased it after 1982 because my wife was the one who suggested I buy it while we were walking though Buena Park Lumberand Hardware. I mentioned that I really wanted one, so she said go ahead and get it (that hasn't happened since.....). We were married in June of 1982. I bought it on sale, without the stand and infeed/outfeed tables, so $1300 for a fully equipped unit would be about right. I remember that the stand and tables cost $295, which I wish I had spent.
Those handles sticking out the front and back are actually carrying handles. The RC33 came out right at the time Makita came out with the first of the viable lunchbox planers and everyone was touting portability, so I guess they stuck the handles on so they could say it was portable. Kinda stretches the definition a bit! While it is possible to move this thing, it isn't easy. That is why I bought it. It had all of the features I wanted from a stationary planer, without the cost. Remember that at that time, stationary planers started at the price of a small car.
The other thing I like is that the head moves up and down like a lunchbox planer, not the table, like a large planer, so setting up infeed and outfeed tables is relatively easy. You don't have to readjust them every time you change the depth of cut like you do on a large planer. If I remember correctly, on the original stand, the tables pivoted just above the handles. I have thought about taking them off my planer. Running into them hurts!
Unless the planer has been abused, you shouldn't have to do more than replace the drive belts, although mine are still original and they run fine. The bearings are all sealed or run in an oil bath. There are a pair of bed rollers that you may want to tweak, but I haven't touched mine since I bought it. To change the blades, you take off the top cover. The blades are easily accessed from one end and the motor position isn't much of an issue if I remember correctly. I have only changed the blade a few times - I don't feed junk into the planer and cut around knots first if I can.