Re: buying Table Saw questions
Dale Penkala
Hello Barry
I have the baby to that saw. Its the G-0690. Only reason I didn't get the larger model was my saw is in the basement and I don't have a large enough shop to handle an 80" plus tablesaw. Rip capacity is around 30" or so, but everything else about the machine I believe is identical. I just got it about 2 months ago and have done several smaller projects. One that I used the saw to cut 1-3/4" red oak for some table legs. I cut thru the wood like butter and it should with 3hp. Fit and finish is very good! I'm very happy with it and recommend it to anyone interested in it. I have only this pix and it don't show the saw really well but it will give you an idea. As stated before I'd definatly contact Grizzly over ebay.
If there is one thing I don't like is the miter gauge is a heavy duty unit that is made of cast iron which after using it a couple of times begins to scratch the top. I didn't like this for not only the scratching but ware factor I put teflon tape on the bottom which took care of that problem. Down the road I may look at an incra miter gauge but for now this is a very usable gauge. If you do anything similar to what I did (made an extention for it) its just that much better.
Personally if he isn't doing anything extremly heavy duty I think it would do a fine job for him. Its done everything I've wanted it to do and I know for a fact it will do everything I want to do in the future.
Hope this helps!
Dale
Mid-Michigan
