It has its limits/issues.
Ed Snow
>None of which really affects one all that much.
First let me say that I really push the limits of what can be done with a tool.
1. Zero clearance inserts, I can't find them, the ones they sell have way too much play and are zero clearance for only a few minutes. I wish I could figure out how to make them (I wish I had the time to figure out how to make them) If you have to have it you have to put an auxiliary mdf top on the saw, plunge through it then make your cuts, this is only for ripping, crosscutting with a sled is zero clearance.
2. You can't stack blades with spacers for multiple ripping cuts or cheek cuts on tenons. I imagine you might be able to with metal washers but I have yet to be that desperate.
3. Some thin kerf blades don't work but some do, the literature is contradictory.
4. Blade ring, this saw is the worst I have ever used with regards to this. I do not know why, the blade does not matter. Riving knife in, riving knife out. Fence set dead parallel of kicked out a few thousandths. No fence only crosscutting. Forrest, amana, freud, tenryu full kerf/thin kerf none of it makes a difference.
5. The riving knife is 1/8" too tall from the manufacturer, the adjustments provided are not enough to accommodate all blades so you have to modify it.
6. You can set the brake too close to the blade and it will fire when you start the saw, kills the cartridge but not the blade.
7. They should have put a uni-fence on it.
8. It is not a 14" saw, well not yet. 12" is in the pipeline.
9. The arbor is 1/4" too short.
Note these are not issues of one saw, I work on four of them.
Despite that, it is a great saw the problems that is has are none that make it a poor tool. It is not the best cutting table saw I have ever used but it does the job as well as a 10" powermatic/general/delta cabinet saw (which I also use). At the end of the day, I try to convince all of the students who ask me as well as anyone else that this is the only saw they should consider buying.