Est. 1998 — 27 years of woodworking knowledge
Jaw screws
Nick Todd
Hi Guys,
After moving to Oklahoma last year, I am close to gertting my shop together. In my move, the box that my chucks in it got wet. Some are going to require quite a bit of clean up. I plan on replace the screws that hold the jaws in place. I have more than ten chucks. Do any of you have the part numbers & suppliers for the screws. I need them for the Nova & Oneway chucks.
Thanks!
Check with Fastenal-
john lucas
I bought metric screws for my Vicmarcs
Re: Jaw screws *LINK*
Jeff Willaford
Teknatool has the info here for their Nova chuck screws.
http://www.novatoolsusa.com/NOVA-Chuck-Fastening-Spares-NSFK.htm
Re: Jaw screws
Don Tewell
You can get metric and imperial at your local Ace. I have replaced a couple of my Nova screws from Ace.
Re: Jaw screws
Mike Mills
If you just need the screws for your Nova.
Toolsplus has three sets (24) for $16.97 or a single set for $7.99.
Much better than NovaUSA for $13.99 for one set.
http://www.tools-plus.com/searchresults.html?query=nova+screws&et=4b04840e&vwentropy=1258487150&x=38&y=5
Re: Jaw screws
Clifton C
Just bought these for my OneWays, item # 6DU64 from Graingers, 100 for 15.40
Mcmaster has them for 10.73 but I was impatient.
cc
Oneway *LINK*
Bill Howatt
Craft Supplies has 8 screws for the Talon/Stronghold for $6.95. Link below.
First one I came across so there are probably others.
Re: Jaw screws
Jesper, Denmark
They are hardened M6 x 15 or M6 x 20 with internal hex drive. I am not near my lathe now, so you can measure the length from the flat to the end of the screw.
Buy a box of 100 from a supply house and you have plenty spare to get lost in the shavings.
Re: Jaw screws
Mike Mills
The Nova jaws screws are M6 X 10. If replacements are much longer (15, 20,etc) they may not seat and tighten. Also make sure they are of appropriated hardness, all of mine are 10.9 or 12.9 on those stamped Nova.
Rockler has the set of 8 for $4.79.
Re: Jaw screws
Robert Lalonde
Me too. And they're a dollar or less each.
Re: Jaw screws
Nick Todd
Thanks for info guys!