Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Shift Knob

Posts

Shift Knob

#1

Shift Knob

Ken Cutler

Has anyone turned a shift knob for a floor shift? I was asked to turn one and I have no idea of dimensions for the basic round knob. Any help would be appreciated. Thanks.

Re: Shift Knob

#2

Re: Shift Knob

David Walser

Are you asking for the dimensions of the hole in the bottom of the knob with the appropriate thread pitch? I don't recall there being a standard size. Last time I turned one, I had my friend find a threaded insert that matched up with his shifter. I then epoxied the insert into the bottom of the blank and threaded the blank onto a bolt. I mounted the bolt into my chuck's pin jaws and turned the knob.

As for the size of the knob itself, there isn't a standard size. Whatever fits well in the driver's hand is the correct size. Start with the size of billiard ball and go from there.

HTH

Re: Shift Knob

#3

2" diameter

Dick Coers

Is what Jegs sells for their classic knob. Make sure you know the thread size for the insert. Lots of options there.

Re: Shift Knob

#4

Re: Shift Knob

Janice Manuel

One of the odd jobs I've done was make gear shift knobs for a boat manufacturer..made like 700 of them...these finished about 1 3/4" diameter and had a brass threaded insert. Put those in with a bit of epoxy..These were mahogany, got a dark stain and a urethane finish....