Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Latest project

Posts

Latest project

#1

Latest project

clay foster

The knob on the fan control on my truck broke after 12 years. I don't even want to know what a replacement from Toyota would cost, so I turned one out of maple with a little chatter work to dress it up.


Re: Latest project

#2

it's probably a $300 knob


Re: Latest project

#3

But Clay, where is the dot to act as reference?


Re: Latest project

#4

Re: it's probably a $300 knob

clay foster

That's still cheaper than what a Toyota dealer would have charged.

Re: Latest project

#5

Re: it's probably a $300 knob

john lucas

Clay I only have one key for my Honda that I bought used. I went to Honda to get a new key because you can't have them made anywhere else. It is $300. I told them they could keep it. The key itself is laser cut and only one place in town can actually do that. The Key Fob which you have to have is only sold by Honda. I can buy a Vale' key for $150 that will at least let me drive the car. Man that's nice of them.

Re: Latest project

#6

That's Cool-or Hot-as needed.;-)


Re: Latest project

#7

Re: it's probably a $300 knob

Barry Irby

John, My son had the same predicament. We found a local locksmith that can cut the key, but did not have the blank. He bought the blank on E-bay (think) and is going to get the local guy to make the key. I think he is getting two for about half of what the dealer wanted. I check out the details if you care and if you think it might help.

Re: Latest project

#8

Re: That's Cool-or Hot-as needed.;-)

walta

So how did you make the “D” shaped hole to fit the shaft?

Walta

Re: Latest project

#9

Re: That's Cool-or Hot-as needed.;-)

rd_macgregor

Last time I made a knob, I made the D-shaped hole by first drilling a round hole then half-filling it with an appropriately-sized dowel that I dragged on the sander until half its diameter was gone. It worked fine, except that a wooden knob on a crock pot (my application) has a limited working life; next time I'll use a chunk of plastic of some sort.

Re: Latest project

#10

Re: That's Cool-or Hot-as needed.;-)

clay foster

Toyotas have a square shaft. I drilled a round hole in the knob and squared it up with a chisel.

Re: Latest project

#11

Re: That's Cool-or Hot-as needed.;-)

Dwight Rutherford

rd, Corian should work well for this.