Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

tailstock adapter

Posts

Re: tailstock adapter

#26

Brad Vietje

Is THIS What You Have Dave?

Brad Vietje

Here's a photo of the Buffalo WL-4:


And here's a page that shows the WL-6 (I haven't found other models):

http://www.auctionflex.com/showlot.ap?co=56323&weiid=11079734&lang=En

Are either of these close? Should be easy to adapt a #2 MT tailstock from another lathe to fit the bed, which would give you more flexibility.

Safe spinning,

Brad Vietje

Newbury, VT

Re: tailstock adapter

#27

Dave

Re: Is THIS What You Have Dave?

Dave


The pics you sent are of the same brand but mine is a different model. I have a WL-6. I've included a pic of it. I stiffened it up by attaching the table to 2 2" square tubes the full length of the table. The reason i did that is because the first time I tried to tighten down a piece of wood to turn the whole thing started to twist. It is pretty much rock solid now. I didn't put the tail stock or the tool rest on for the pic. I hope this pic comes through OK.