Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Stuck steb center point

Posts

Stuck steb center point

#1

Stuck steb center point

Wayne Leach - NW Ontario

Has anyone any knowledge of the construction of a steb center, more precisely a PSI unit?

Yesterday when completing a turning I noticed that the spring loaded centering pin was stuck at the depth of the serrated teeth. Cant see how it was put together. Tried to free it using penetrating spray thru the setscrew hole and tapping on the pin axially with a hardwood dowel with no luck.

Heated it up with a torch thinking the hotter body would expand and release-NO joy. Anyone got any ideas or is this a mini boat anchor?

Thanks in advance,

Wayne

Re: Stuck steb center point

#2

Re: Stuck steb center point

D. Hansen

done that, There is a small flat on the pin. the set screw rides on the flat. If you "carefully" remove the screw the pin just might slide out. It might also join mine somewhere in the depths of my shop if your not careful. The flat might be gummy or the screw is too tight. Darryl

Re: Stuck steb center point

#3

Re: Stuck steb center point

Robert Lalonde

Mine got stuck like that too. Turned out to be dried resin. After I soaked it in solvent, all was well. I'm buying a Sorby next time.

Re: Stuck steb center point

#4

Re: Stuck steb center point

Wayne Leach - NW Ontario

Thanks for the tips everyone. I AM DETERMINED TO SALVAGE THIS AND I DON'T GIVE UP EASILY. Will soak it overnight in thinner and if that does not work will grind flats on the cone for vise grip and try that. As a last resort I guess I will chuck it in my metal lathe and bore thru the #2 MT so I can punch it out ( if the metal is not too hard to drill)?

Re: Stuck steb center point

#5

Re: Stuck steb center point

Darryl

Wyane If you loosen the set screw you should be able to pull the pin out. There is a spring behind the pin that is under compression though and if your not careful it will push to pin out. The spring may also be gummed up. Instead of thinner you might have better luck with turpentine or "liquid wrench" type products.

Re: Stuck steb center point

#6

Lyle Jamieson

Re: Stuck steb center point

Lyle Jamieson

Likely, your set screw was tightened on the shaft of the pin. When it gets scarfed up it will be hard to get in or out. Seems backwards, but tapping it in farther might loosen up the problem and allow it to come out unless the spring is compressed to the max..

Re: Stuck steb center point

#7

Re: Stuck steb center point

Wayne Leach - NW Ontario

I just want to thank everyone for their most helpful suggestions. I finally was able to get the point free but not until I exhausted all the suggestions. After many trials I decided to drill thru the setscrew hole with a 1/8" bit just enough to allow a 1/8 punch to get a purchase and allow me to pry it just enough to get the point far enough out to grind flats with a Dremel. This allowed vise grips to hold enough to finally wiggle it free. Cleaned out the bore and machined the point on my metal lathe and it is now functioning like new. The small flats do not affect the centering of the wood. Perseverance finally paid off and it was worth it-I did not want to accept failure, it must be a guy thing! I will make a mental note to remove and clean more often.

Re: Stuck steb center point

#8

Re: Stuck steb center point

Brian Roberts

NEVER give up! :)

Good on ya!