Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Plates

Posts

Plates

#1

Plates

clay foster

I've wanted wood plates for a long time, and finally got some made. The wood is beech, that I roughed out a couple of years ago. Some people think beech is prone to cracking, but if you treat it gently, it is rewarding. I also made a maple bowl while I was turning kitchen ware.


Re: Plates

#2

Beautiful!


Re: Plates

#3

Re: Plates

Jennifer Indy.USA

I do love these plates. They will serve many meals made with love.

:)

Re: Plates

#4

Re: Plates

Barry L Elder

Are they food safe?!!! :D No, I don't mean to eat, unless they are very tasty! ;) They look great! and people have been using wood plates, platters, trenchers, and utensils for thousands of years. I keep the ones I made for various uses 'cause I couldn't put up with all the idiotic questions from the public. It's a shame so few woodturners spend so much money on kitchenware when they could make their own. A "call to arms" in the kitchen!!! :D Enjoy with great joy and love!!!

Re: Plates

#5

Re: Plates

Rum

Those are great, nice job on the shape of the plates something to add to the queue.

Re: Plates

#6

Steve Kubien

Re: Plates

Steve Kubien

See, I knew you guys were turning kitchenware!

Re: Plates

#7

Ellis Walentine

Need advice, Clay...

Ellis Walentine

I've wanted to turn plates for a long time, too. I have piles of interesting lumber that would make wonderful plates, but I don't know a good, quick and easy way to turn them. Did you use vacuum? Cole jaws?

Ellis

Re: Plates

#8

Re: Need advice, Clay...

clay foster

I roughed out the blanks from green beech a couple of years ago, and left the tenon on them. If the tenon gets too out of round to go back into the chuck, it can be trued up again by mounting the plate over the chuck jaws and holding it in place with the live center in the original hole.

My method for cleaning up the bottom after the plate is turned and sanded is pretty low tech. I turn a recess in a blank of wood and secure the plate in place with little sticks and screws. The plates are within 1/4" of being the same diameter. Start with the smallest plate and increase the diameter of the recess as needed. If it's a little loose, shim it with precision masking tape. If it's a lot loose, make the recess deeper.

If I were a production turner, I would probably have a vacuum chuck. But, I'm an analogue guy in a digital world.


Re: Plates

#9

Re: Need advice, Clay...

Clifton C

Oh no...PMT, is that from 3M ? :)

Re: Plates

#10

Re: Need advice, Clay...

clay foster

It's a Sorby product. Woodturner's precision masking tape. WPMT. It comes in both blue and tan.

Re: Plates

#11

Ellis Walentine

Nifty tip. Thanks!

Ellis Walentine

Analog works for me. I'll have to give that a try. I guess it's pretty important to use dry wood, or let the rough plates dry before turning, to keep them from becoming potato chips.

Thanks again for the pic.

Ellis

Re: Plates

#12

How ya doing Steve!?

Ray Carson - Lawrenceville, NJ

Long time no see.