YouTube clip
Lyle Jamieson
Check out the new YouTube clip from Carl Jacobson. I had the pleasure of working with him while I was out to the Oregon Symposium.
Knowledge You Can Build On — Est. 1998
YouTube clip
Lyle Jamieson
Check out the new YouTube clip from Carl Jacobson. I had the pleasure of working with him while I was out to the Oregon Symposium.
Re: YouTube clip
robo hippy
I enjoyed chatting with Carl as well. First time I ever met him. We decided that we need to do a play date some time....
robo hippy
Re: YouTube clip
Bill Jacksonville, NC
I totally enjoyed the video although not for the faint of heart. That jam chuck definitely adds lot of drama!
Re: YouTube clip
Alan Zenreich
Nicely done.
I always enjoy watching/listening to Lyle demonstrate.
Is there any benefit to the jam chuck being as wide a piece of wood as it is shown in the video?
I would think that it only needs to be large enough to secure in the chuck and accommodate the hole. Does the extra mass of the larger piece of wood add anything to the project?
Would a smaller 'propeller' , possibly round or with rounded ends be a little less likely to contribute to a mishap?
Thanks again, and looking forward to seeing you at Totally Turning I'm a few days.
Re: YouTube clip
Lyle Jamieson
Yes, you are correct the block was oversized and overkill. When I did the prototype at home with a 2X4, and the chuck tennon split off. So I wanted to error on safety and use bigger, stronger stock then was necessary. I have lots of experience with voids, natural edges and understand the risks. It takes total concentration. One careless move could hurt you. Carl is a great guy, and the Oregon Symposium was a huge success, and I spent some wonderful time with two of my grand kids in Portland.