Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Carving jig for bowls

Posts

Carving jig for bowls

#1

Aage Rendalen

Carving jig for bowls

Aage Rendalen

Since I had an unused mini-work bench, I made use of it to create this super-simple holding device which will allow me to care bowl rims or otherwise decorate them without any problems. You could, of course, use two pieces of MDF joined together with a loose back plate, but the work bench gave me an extra lift and a more convenient work height when sitting down. I have two back plates, depending on the diameter of the bowl.


Re: Carving jig for bowls

#2

Re: Carving jig for bowls

John Lucas

I like it and hope to use mine similar in the new shop. It's been a temporary support for my miter saw but that's going away when I build up the new shop.

Re: Carving jig for bowls

#3

Speaking of knitting...

Ralph Lindberg

Some knitters prefer yarn bowls with a "j" slot carved into the side