Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Not Charlie-but

Posts

Not Charlie-but

#1

Not Charlie-but

John Lucas

I haven't been turning much lately since I'm trying so hard to get my house ready to sell. I did start building one of the seg easy miter jigs and needed knobs so I turned these 3 sided knobs and glued T nuts in the bottom. Turned on 3 centers like Barbara Dill teaches. It's quite challenging getting clean cuts without tool marks. I found the best way to help match the 3 sides and at the same time to get cleaner cuts was to turn it 3 times. By that I mean 3 times at each of 3 different centers. This allowed me to measure the width of the sides and take off more on one than the others to even them out. Since I was taking smaller cuts it also helped with the tool marks. well that and using the wings of the spindle roughing gouge as mini skews. After turning the 3 sides I put it between centers and turned most of the top and bottom of each knob. I turned a seperate tenon on the bottom so I could cut them apart on the bandsaw and mount them in a separate chuck to finish turn and sand the top. Fun project.

Re: Not Charlie-but

#2

Re: Not Charlie-but

Philip Duffy

Very nice job John! P.

Re: Not Charlie-but

#3

Steven Antonucci

talk about timing...

steven antonucci

I need to make a knob for my inkle loom...

S