Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

getting some interesting wood

Posts

getting some interesting wood

#1

getting some interesting wood

Mike Potts

Wife sent me into town to pick up a few grocery's saw this wood along the side of the road. I stopped and asked if I could remove it for them. they where happy to have someone take it. The large piece is better than 3 ft across. I'll be back toma rrow to cut it into pieces to load into truck. Any ideas on cutting the large piece?







keep it safe

Mike

Re: getting some interesting wood

#2

Re: getting some interesting wood

john Veerkamp

at that size and the color it may be Box Elder.

Re: getting some interesting wood

#3

Jesper, Denmark

Re: getting some interesting wood

Jesper, Denmark

No matter how you decide to cut it, it will yield some surprises, so have at it.

Re: getting some interesting wood

#4

Re: getting some interesting wood

Mike Potts

Yep Jesper, looks like I might have some good stuff to turn, sort of wish I was into HF's. went through tank and half of gas and not nearly done. I've only got 18" bar so It's been a challenge just to get it in samall enough pieces to handle.



keep it safe

Mike

Re: getting some interesting wood

#5

Do you know what kind of wood yet?

Keith Newton

Too late, but I would have suggested cutting horizontal across the middle of the lower picture above, with a good possibility in the middle of the top, in between.

One thing that may help, is to knock a little of the bark off with a hammer, so you can see what kind of figure lies beneath. I like to use a 20 oz framing hammer, striking at about 45º. It is easies in Spring, and hardest in Winter, but still doable.

The Arborist call this portion of a tree a "cathead". How it got that name, I don't know.

Re: getting some interesting wood

#6

Re: Do you know what kind of wood yet?

John Jordan

The wood is sugar maple. I prefer the 18 inch bar most of the time, its easier to maneuver, and you can cross cut a 36 inch log.

If you are cutting down into the end grain, the way it is in the picture, it will take a long time and is very hard on the chain and saw. Turn the log on its side and cut along the grain and/or cross cut it across the grain. Leave it as big as you possibly can, then keep it covered tightly and cut it as you use it.

John

Re: getting some interesting wood

#7

Better file down the rakers

Dick Coers

....if you've used up a tank and a half of gas already. The tree crew probably used about that much to drop the entire tree. As John said, put it on it's side if you aren't done. But, those multi crotch pieces are plain hard to cut. Long grain, short grain, crotch grain, all those make it hard to cut. Also stay out of that black decayed spot. For some reason that I've never figured out, those tend to be very abrasive.

Re: getting some interesting wood

#8

Finished cutting today

Mike Potts

John you are right on, it is sugar Maple, but it is a dead stand and has already started some spalting. I ended up cutting cubes of sort most 12" to 16", luckly the homeowner was there and was able to help me lift them into the truck. I only have a 1/2 ton truck and it did make it squat down some. yes it was some tough cutting, but I think it will be worth it.







keep it safe

Mike