Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

How the blankety-blank do you keep padauk from...

Posts

How the blankety-blank do you keep padauk from...

#1

Steven Antonucci

How the blankety-blank do you keep padauk from...

steven antonucci

bleeding into everything else in glue up work!

I have it sitting next to some really nice white maple, until I sand it or try to apply a clear finish. Then, it just makes everything orange.

Thankfully, I am out of it... but I have two items I'd like to finish for the holidays.

Help!

Steve

Re: How the blankety-blank do you keep padauk from...

#2

Re: How the blankety-blank do you keep padauk from

John Lucas

Steve the thing that works for me is to put sanding sealer (or thinned lacquer) on before you start sanding. Then after each grit blow all the dust off you can and then apply another coat of sealer. Do this between every grit and you will probably succeed.

Re: How the blankety-blank do you keep padauk from...

#3

Steven Antonucci

tried lacquer?

steven antonucci

I think it bled from the solvents in the lacquer?

The things were cut with a skew, so they don't really need to be sanded. I need to get a can of sanding sealer

S

Re: How the blankety-blank do you keep padauk from...

#4

Re: tried lacquer?

kkruizen

I generally use Danish Oil (Watco) and sometimes walnut oil and I have never had bleeding. Most of the time I buff it out with Tripoli only otherwise the white diamond gets into the open grain. I rarely use a building finish either because of the open grain.

Re: How the blankety-blank do you keep padauk from...

#5

Re: tried lacquer?

gary clarke

padauk is nasty stuff, in addition to getting all over the house and your hair it is difficult to keep from bleeding. I quit using it and instead use bloodwood for segmented turnings.

Re: How the blankety-blank do you keep padauk from...

#6

Shellac

Mark Mandell - Gone Round In New Jersey

1 lb cut applied between each grit. Use a DC of shop-vac with micro filter right next to the abrasive contact point. Then vac off with a brush, and reapply shellac sealer. Don't blow off with air unless you want to wear it.

If you do segmented with the stuff next to white, can't help you, just don't ;)

Re: How the blankety-blank do you keep padauk from...

#7

Shellac

Geoff Whaling

I use a lot of New Guinea Rosewood which is a very close relative of Padauk. I particularly like the deep orange & some of the purple variants if I can get it for my linear lamination work. It gets laminated up with white or near white veneers that are only 0.6 mm thick at times so bleeding of the oils in the NGR is a problem. The deep orange is always problematic and definitely has more "aromatics" in it than the other "browns" you get with NGR.

The advice on applying a sealer either shellac or nitro cellulose sealer is good. Shellac is less problematic than a NC sanding sealer to prevent the solvents from dissolving and transporting / bleeding the oils into the whites. Spraying is better than wiping or brushing.

I concentrate on obtaining an excellent off the tool finish on these pieces to absolutely minimize sanding.


ps filling open grain with the old french polishing trick of using talc is also helpful. The outcome is never guaranteed though and the configuration of the grain has a huge bearing on the outcome.