Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

OTC quality threaded rod and long nut

Posts

OTC quality threaded rod and long nut

#1

Aage Rendalen

OTC quality threaded rod and long nut

Aage Rendalen

I'm making a threading jig and I've run int a problem: the threaded (3/4" x 10 tpi) rod I bought at Home Depot is pretty bad. At least, when I tried to force a 2" inch nut to run the length of the rod, I ruined a section of the thread. Whether it was the female or male thread that was the problem, you apparently need to avoid the big boxes to get quality metal thread. Any suggestions--short of a metal shop?

Re: OTC quality threaded rod and long nut

#2

Re: OTC quality threaded rod and long nut

Ivan Clark

You need to match the type of thread (not just the diameter and pitch) when you are dealing with threaded rod.

I would suggest a visit to the place where you bought the threaded rod and the nut. They may replace them for you (may not), but they should at least be able to help you find a matched set. Of course, this does assume that they carry matching nuts. That would be a bad assumption for buying extra nuts for the eye screws that they sell.

Re: OTC quality threaded rod and long nut

#3

Re: OTC quality threaded rod and long nut

John Lucas

I've always bought my threaded rod at Lowes or Tractor Supply. I've made a lot of jigs that use it and never had a problem with the nuts traveling down the thread. In fact it's usually a little too sloppy of a fit. I think you got a defective piece.

To eliminate the slop in my homemade threading jig I used all thread connectors that I cut in half and then made a piece to apply pressure onto the half nut. With the right amount of pressure I got a fairly easy movement when cranking the screw but very little slop.

YOu can get threaded rod from metal supply houses. I purchased some fine thread rod that was 12" long and it had extremely clean threads. I wasn't looking for 3/4x10 so I can't tell you the quality of that.

Re: OTC quality threaded rod and long nut

#4

Re: OTC quality threaded rod and long nut

Chuck Engstrom

Hi Aage -- you might want to look into using Acme threaded rod and nuts, a more precisely manufactured type used, as I understand it, not for fastening but for imparting motion, which might be the right fit for your project.

Try www.msc-direct.com and search for "threaded rod" (the Acme stuff will come up) and for "acme nuts."

Good luck with your project -- Chuck

Re: OTC quality threaded rod and long nut

#6

Dennis in Southern Oregon

Re: OTC quality threaded rod and long nut

Dennis in Southern Oregon

Utility grade all-thread rods and standard nuts usually yield a sloppy fit. You can remove the backlash by using a pair of nuts jammed together instead of a single nut. Jam the two nuts together with just enough torque to take out the backlash and lock them together with a few drops of CA glue on the outer edges.

Dennis

Re: OTC quality threaded rod and long nut

#7

Re: Try Fastenal for UNC and Acme