Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Drawer knob question

Posts

Drawer knob question

#1

Drawer knob question

Jack Savona

I've been asked to make some drawer knob replacements out of mahogany, 2" dia..

End grain or side grain? Aside from appearance, any structural issues I should be aware of if it's side grain?

Thanks in advance!

Re: Drawer knob question

#2

Re: Drawer knob question

john Veerkamp

In side grain I'd be concerned about it splitting at the narrow area.

Re: Drawer knob question

#3

Mike Peace

Re: Drawer knob question

Mike Peace

For that size I would not worry about splitting. The decision may be based on what size wood you have. Also, end grain will tend to hold more stain and be darker.

You might find my YouTube on turning knobs helpful. https://www.youtube.com/watch?v=CsfWQoOIkNw

Re: Drawer knob question

#4

Re: Drawer knob question

John Lucas

I'm with John unless the minimum diameter is 2". Drawer knobs can take a lot of abuse so end grain would be better

Re: Drawer knob question

#5

Re: Drawer knob question

Jack Savona

I appreciate all your comments and suggestions.

Mike, saw your video before and watched it again. Well done.

Re: Drawer knob question

#6

Brad Vietje

Re: Drawer knob question

Brad Vietje

(Hmmm... musta lost my cookies... no profile or font options came up...)

Like everyone else, I'd use end grain for knobs/pulls that have a narrow dimension, but I have used side grain for short, wide pulls to match those from a set of bureaus made in the 1860's -- about 2.75" wide by only about 1.25" tall; "narrow" dimension was still about 2.25".

Safe spinning,

Brad Vietje

Newbury, VT