NEW idea for turning...
darrin hill
at least i hope it's new…
Went to the texas renaissance festival yesterday… Just wandered around looking for woodworking booths… pretty much all tourist junk..
but i wandered by a booth and this guy had bowls that were about7-8 inches wide… and were plastic looking, but with white, black and clear streaks…
I asked him what they were made of and he said cow horn… I said impossible cause there was no solid cow horn big enough for a blank that size.. he smiled and told me how he does it..
he cuts a section of horn out about 8 inches long… then cuts one side on a bandsaw… so think of a 8 inch piece of pvc pipe with a slot cut..
Then he pops it in the oven at 350… this softens it so that it is bendable…
he puts the hot horn scroll on a sheet of metal and uncurls it.. then puts a heavy weight on it…. after it cools you have a big sheet of cow horn…
Then he cuts out circles on a bandsaw…
pops the disk into a deep fryer full of grease… (Not sure why it cant be put back in the oven..)
then puts the scorchingly hot grease covered blank in a bowl mold and uses a 4 ton press to push it in the mold… it cools and you have a bowl..
thought it was interesting…
I got his card.. thought i could someday buy some blanks for something…




