Re: HEPAFilters
Randy Johnson
I could be wrong, all wet, whatever, but something I seldom, if ever, see mentioned is how much height from floor to ceiling is needed for a good cyclone set up.
My shop has eight foot walls sitting on (I think) an eight inch poured foundation. With the cyclone mounted so the top of the motor touches the ceiling, one of Oneida’s tall drums is only a few inches under the bottom of the cyclone. I have doubts that there is enough space for the cyclone action to work properly. I base this statement on the amount of dust that falls into the pan at the bottom of the filter. Others talk about the small amounts they have. Mine is usually pretty much full, with many times more the amount on the walls of the filter. I would like to have at least a couple of feet between the bottom of the cyclone and the top of the drum, and if I had it to do over again I would have dry walled the ceiling so the cyclone was mostly in the attic.
Something else I should have done – and will eventually – is install a series of four way switches near each machine to do away with the remote. Mine will not work if I have any lights with a T-8 ballast turned on.
I bought my cyclone when I started work rehabbing the former two car garage that was to be my shop. The job turned out to be a lot more difficult (termite infestation) than planned, and it was over a year before I started work mounting the cyclone. I found that they had sent me the wrong center section. A phone call to Oneida resulted in the information that, due to design changes since my unit was shipped, they didn’t have anything that would work. They had to make a new center section for me. It was delivered in a reasonable time frame, especially under the circumstances. I think that says volumes about their customer service.