Bandsaw up and running
John Lucas
For those who are following my bandsaw adventure. My saw quit running it seemed like the switch which is a magnetic switch so I ordered a new one. The switch came but apparently the coil that operates it is seperate. I installed it nothing happened so I call the company and get a new coil on the way. It comes in and still the machine is not working.
I check all the wiring thinking that I may have hooked it up wrong because the schematic doesn't have any color code on the wires. I trace them all to where they should go and everything seems good. I called the company and talked with their rep. I check all the interlocks and then verify that I have 220 going to the coil. Still no luck.
At this point I had to stop for my cancer treatments for a month. so I do some more checking when I get back and still think it's the coil even though it's new. I discuss this with the reps and we go back and forth over a day or so with me checking more wiring and voltages but I'm still sure it's the coil. I'd already hot wired the motor and the bandsaw ran great. I wired around the interlocks to eliminate them as well.
The rep was really good and helped me understand how that very complicated switch works. Anyway, he agrees to send me a new coil. In the meantime he calls back and tells me they have a whole box of defective coils. The new coil solves the problem and I now have an operational machine.
I'm relieved because I didn't think my electronic trouble shooting skills were that bad. It's really difficult trouble shooting a problem when the new parts are bad.



