Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Bent Lamp Auger

Posts

Bent Lamp Auger

#1

Bent Lamp Auger

Blondterror

Any suggestions on how to salvage this lamp auger.. I stopped using it 2 yrs ago when I bent it and now need to make some more tall lamps


Re: Bent Lamp Auger

#2

Heat and patience

Dick Coers

Probably heat, but since it not break, it may not be hardened. I would still heat it, then start the hammering. Strike and roll to check straightness. Keep that up till it's straight enough. Likely not to get perfectly straight, but I imagine you're spinning the blank on the lathe. You could work in the corner of angle iron, but you have to over bend it to get it straight.

Re: Bent Lamp Auger

#3

No heat needed

John Lucas

I would straighten like I straighten arrows. I have also used this method to straighten blow pipes for glass blowing. Basically you put some V blocks under both ends usually centered on the bent area. Rotate it so the high point is up and then push down on that area. Takes patience but I e done many arrows so they were perfectly straight

Re: Bent Lamp Auger

#4

You use steel arrows? LOL


Re: Bent Lamp Auger

#5

Aluminum. Back in the days before carbon fibre


Re: Bent Lamp Auger

#6

Leo Cuellar

Re: Bent Lamp Auger

Leo Cuellar

I would try without heat as well. A hard & heavy plastic or wooden mallet to save wear & tear on the flutes. Copper mallets work well also, if you have one. Brass is sometimes too hard for delicate items.

Re: Bent Lamp Auger

#7

Re: Bent Lamp Auger

John Lucas

Just rig up a lever. Clamp a board to your workbench with spacers underneath Then put a board under that to push down on the drill. This allows you to flex it down a known amount. With the drill in the v blocks you can easily flex it beyond horizontal which you will have to do to get it perfectly straight.