Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

3520 creaking noises

Posts

3520 creaking noises

#1

3520 creaking noises

Chuck Engstrom

I'm beginning to hear little creaking noises that seem to come from inside the headstock. Am I right in assuming that this is a message to replace the bearings?

Are good local machine shops capable of this or does it really need to go home to Tennessee?

Any info is welcome --

Thanks -- Chuck

Re: 3520 creaking noises

#2

Re: 3520 creaking noises

robo hippy

Sounds like bearings. If the spindle shaft is not rotating smoothly, then for sure that is it. I had mine replaced at a local tool repair place. I got new bearings, a belt and had the work done for less than I could get parts for through PM. I did have to haul the whole headstock down to them.

robo hippy

Re: 3520 creaking noises

#3

Re: 3520 creaking noises

John Lucas

Could simply be belt alignment. I would check the alignment of the pulleys and tighten the set screws while your at it. Also check the belt tension

Re: 3520 creaking noises

#4

Re: 3520 creaking noises

josh bowman

+1 on belt. Do you hear the noise while it's running or when you're rotating it by hand. General bearings make clicking noise. But my belt will creak most often if I have it too tight.

While on the subject, it's my opinion that the PM 3520b has a slight design flaw. I feel that the motor shaft is too long and if you press down on the tension lever too much you can put too much leverage on the front bearing and break it. At least that's what I blamed my broken motor bearing on. So now I just let the weight of the motor tension and no more.

Re: 3520 creaking noises

#5

Keith Tompkins

Re: 3520 creaking noises

Keith Tompkins

Chuck, one way to check bearings is to loosen the belt, then put your hand on the headstock near either bearing, and spin the shaft by hand. You can FEEL a bad bearing; once you know what a bad bearing feels like...it's foolproof. The creaking may be a over-tightened belt.

Re: 3520 creaking noises

#6

Re: 3520 creaking noises

Chuck Engstrom

Thanks, folks. I've checked everything suggested and don't think I need new bearings now. I may have been hearing some creaking in a jam chuck. I can't get any noises at all with everything removed -- chucks, belts, etc -- so I guess I'm OK or the time being.

Re: 3520 creaking noises

#7

Re: 3520 creaking noises

John Lucas

Chuck. Some things only show up under pressure. Put a scap of wood in your chuck and crank the tailstock up against it. No noises no problem. You will frequently get little squeaks from jam chucks and they usually happen on a

1 revolution basis so it can sound like a me handicap problem

Re: 3520 creaking noises

#8

Lyle Jamieson

Re: 3520 creaking noises

Lyle Jamieson

If the headstock and tailstock do not line up, that causes creaking sounds with friction drive reverse chucking or jam chucking.