Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

removing 20 in sanding disc

Posts

removing 20 in sanding disc

#1

removing 20 in sanding disc

gary clarke

Any one have any suggestions on removing a 20 inch 100 grit sanding disc from my disc sander? I have a 12 disc sander also and have had no difficulty removing sandpaper from it. I tried acetone, paint thinner and denatured alcohol and each made a huge mess. The sandpaper was klingspore 100 grit. It took over an hour and I still have glue on the metal disc. grrr

Re: removing 20 in sanding disc

#2

Re: removing 20 in sanding disc

Dick Coers

I like a single edge razor blade scraper followed up with lacquer thinner. It's still going to be messy. For tough ones like that, I like to use an industrial heat gun to warm up the adhesive while the disc is still in place.

Re: removing 20 in sanding disc

#3

Re: removing 20 in sanding disc

robo hippy

Some rubber cements can have very specific solvents. I used a lot of Barge Cement, and mineral spirits worked best for it. Paint thinner, not so well. I was thinking a razor blade type scraper as well to take off the bulk. I hadn't thought about heating it first.

robo hippy

Re: removing 20 in sanding disc

#4

Mike Stafford

Re: removing 20 in sanding disc

Mike Stafford

I have this problem with my 12 inch disc sander. It is always messy. I have found that heating up the disc before the initial removal helps but you are still left with gummy residues to remove.

I am able to remove my disc so I can place it horizontal. I then cover it with several layers of paper towels soaked in mineral spirits. Goo Gone works pretty well for the stubborn areas. I still have to use a paint scraper, the kind which holds a razor blade to get the worst off.

You can convert your disc holder to hook and loop but the results in use will be different.

Re: removing 20 in sanding disc

#5

Re: removing 20 in sanding disc

Joe Mohnike

have you tried paint remover or white vinegar? Have used both and had good luck with them.

Just a thought.

Re: removing 20 in sanding disc

#6

Re: removing 20 in sanding disc

Lan Brady

Gary,

After removing all the paper surface with a sharp blade, I use a 1/2" wooden dowel point, lightly pressed against the surface near the center. It genrates heat and melts the glue. slowly advance the dowel toward the rim.

Good Luck, Lan