Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Friction burn

Posts

Friction burn

#1

Friction burn

John Lucas

I was turning a 15" platter this morning While I was sanding it touched the outside with the back of my hand and the friction burned right through the skin. I barely brushed against it Burned me about like when you brush a clothes iron. Ouch.

These posts will have to be short for a while. Lightening damaged my computer a d it might be 10 days before I get it back. Ill be using the phone so messages will be short and probably lots of typos.

Re: Friction burn

#2

Another aging lament.....

Dick Coers

Is thinning skin. Seems to take less for a bleed these days. Not that it would make a difference for the burn, but it sure doesn't help.

Re: Friction burn

#3

BTDT....

Barry Irby

From my construction days, The job ain't finished until BLEED has been declared. Now that I am on blood thinners I seem to bleed all over everything. You have what I call a rim burn. I wear a leather glove with the fingers cut off on my left hand. (A habit we have discussed many times here.) On a platter I cut a very thin sharp rim. Turned the lathe off to look at it. Reached out with my gloved hand and stopped it. That edge sliced that Glove like a knife. Actually ended up with a cut like a paper cut on my hand. If I had not been wearing the glove I would have needed stitches. Or maybe I would have had enough sense to not touch it.

There is some medicine they advertise on TV that says don't take this if you have an open wound. I doubt they are talking about the tiny nicks and scratches I usually have, but if they are, I will never be able to take that stuff. I always have a cut somewhere.