Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Latest turning - Sfirri style candlestick

Posts

Latest turning - Sfirri style candlestick

#1

Latest turning - Sfirri style candlestick

Craig Daymon

I created the first of what I plan to be many more Mark Sfirri style candlesticks today. Bought the bobeche from Lee Valley, which were suppose to be sized in inches, but are metric. Then, after I finished it, I found out the candles I had planned on using are quite a bit smaller than the box stated.


Then, finally, the candlestick ended up being less than 3" tall! (OK, that part was intentional.)

The plan is to make a bunch for use for birthday candles. Not intending to sell any, so Mark's market is safe from me. (I'm sure he was sweating it.) Mark actually offered up some advice on making the sticks before I got started, though not related to the scale. The bobeche I used are actually sleeves for adjustable shelf shelf pins.

No finish yet and some final sanding still to do. Candles were suppose to be 1/4" in diameter. The shelf pin sleeve was suppose to fit in a 5/16" hole. Took an "O" bit instead.

Re: Latest turning - Sfirri style candlestick

#2

Steven Antonucci

two centers?


Re: Latest turning - Sfirri style candlestick

#3

lookin' good

GaryG in MD

I like that "top hat" segment in there. ...GG

Re: Latest turning - Sfirri style candlestick

#4

Re: two centers?

Craig Daymon

Yep. That's the standard Sfirri design for these candlesticks. First set is on farthest safe opposite corners. Second is on the opposite corner on one end and at center on the other (allowing for a larger, more stable, base). All centers sit in the same plane on the center lines of the ends.

There are 2 Woodwork magazines featuring articles where Mark describes the procedure and one in American Woodworker from March 1994. The AW issue/article is available to members in the AAW archive for the journal.

One key point to remember when turning one is to only turn off a VERY small bit of the corners on the base to soften the corners. (Or none at all.) This insures your base will be large enough.