Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

What is this?

Posts

What is this?

#1

What is this?

Chuck Engstrom

Seems to me this piece of gear has something to do with pen-turning but I can't remember what it is or how it's used. Does anyone recognize it? The 0.242 written on the base is the diameter of the protruding rod, which seems to be a good fit for the ID of a standard 7mm pen tube.

Thanks -- Chuck


Re: What is this?

#3

Re: penblank squaring

Chuck Engstrom

Thanks, Jeff. I looked around a couple of suppliers sites but never saw it.

--Chuck

Re: What is this?

#4

Re: This may help, maybe!

Don Evans

Chuck:

Just FYI the brass thing on the rod is moveable. You can put 2 open end wrenches on the 2 places made for them and unscrew the right one off the other half (left part). This device is made for 7 mm rods to be used to take up extra room on a pen mandrell rod instead of using spacers.

Inside it is a compression washer (split ring) but it is what actually does the holding when the 2 pieces are tightened back together.

If you experiement with how much you tighten it and do NOT tighten more than necessary It will last much much longer. How? Screw the two halves together with minor snug and see if you can slide it on the rod with pushing on it to slide it up rod. Tighten more if needed.

It works like a water line compression fitting that has the brass rings in them. Pro plumbers still use those but I hate them for plumbing as I don't have to buy lots of the more expensive metal weave water lines.

You may know all about these brass things if so someone else on this group may get help from this.

It was Craft Supply, Woodcraft or PSI that had the brass things but I don't know if they are still carrying them. If you do many pen type things with the 7mm mandrel they are great to have and save lot of time. I have one with extra rings but don't use it much like I did 20 years ago.

Don PS -- if you take it apart be careful removing the white ring, use finesse removing it from the threaded brass part its just pressed into it due to tightening the two halves together and it is suppose to do that, fyi.

Re: What is this?

#5

Re: This may help, maybe!

Chuck Engstrom

Hi Don -- Thanks for the additional points. I have some familiarity with compression fittings from long-ago work on boat systems so I did recognize that part of it, but couldn't quite figure out what the whole thing was for!

Best, Chuck

Re: What is this?

#6

Re: This may help, maybe!

Don Evans

Good, then u shouldn't have any trouble with it. I always used the pen mills to square the ends but it got expensive cause it wasn't long before they started coming out with pen kits and other stuff with many different sizes of tubes some where 10mm so u needed mills that fit each size tube. I used the mills in my drill press, much easier that way.

Don