Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Raffan on hollowing

Posts

Raffan on hollowing

#1

Raffan on hollowing

TomD

So power outage by power outage, I have been going through the Raffan toy tape. Another thing I notice he has changed is his hollowing peeling from the center cut. I always enjoyed that one, and never actually blew anything off the lathe, or at least, not that I remember. Why no more? Too dangerous, too difficult. At the end of the day, he scrapped to final, so it is all down to how you want to do it...

Re: Raffan on hollowing

#2

Re: Raffan on hollowing

phillip Medghalchi

Tom, you are losing man. What are we discussing here?

Re: Raffan on hollowing

#3

Re: Raffan on hollowing

Dale Miner

Richard was at the OVWG symposium in 2011 and did some hollowing there using the technique.

I believe he calls it the 'back cut' or 'back hollowing cut'. He used it on and end grain piece. A brief chat with him after the demo and he gave me a couple of pointers that make it work better.

Re: Raffan on hollowing

#4

Re: Raffan on hollowing

don stephan

If memory serves, on his box making video he explained that there is a limit to how large a diameter can be hollowed using the back cut. Didn't he switch to scraping when larger interior diameter needed, and to clean up the sides?

Re: Raffan on hollowing

#5

Re: Raffan on hollowing

TomD

There probably is a limit, though on the tape in question he was making a goblet, so well in range. It was always a little wild as a technique as there have always been other ways to do it. I learned hollowing from his first tape, in end grain, and just thought that is how one did it. But one can just cut it like a bowl so long as one finds a way to do it that favours the grain. I assumed his new techniques were just easier and slanted to newbies, anyway, the old tapes are still out there.

For those who are lost, around 00:30 here:

https://www.youtube.com/watch?v=FIbhuYxkn0w

He can crank this so that it really flies out of the piece much faster than here, and it was one of his party tricks, so to speak. This, his bowl roughing with a spindel gouge, back in the days before high horse power lathes and fingernail gouges were in everyone's hands; and his skew roughing. All pretty easy techniques but mucho impressive when he first was teaching.

Re: Raffan on hollowing

#6

Dennis in Southern Oregon

Re: Raffan on hollowing

Dennis in Southern Oregon

Raffan liked to use the back hollowing technique in demos, because it was spectacular. He characterized it as a fast way of getting the bulk of the wood out in end grain hollowing. I have never seen him use it for the final cuts. This cut puts lots of torque on the work piece and the torque gets higher as the diameter of the cut increases. This limits its use in fragile pieces.

Dennis

Re: Raffan on hollowing

#7

Re: Raffan on hollowing

Dale Miner

When talking with him and mentioning that about two inches deep and about 2.5 inch diameter was about as much as I could pull off, he confirmed that was about the limit.

During his demo, the final cuts were done with conventional cuts using gouges and scrapers.

The back cut is fast though for getting the bulk of the wood removed.