Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Update on sticking spindle/chuck

Posts

Update on sticking spindle/chuck

#1

Update on sticking spindle/chuck

Ron Bauer

I thoroughly cleaned all the threaded parts of oil and swarf. Prior to installing any threaded device I blow off the spindle and the insert. No oil and no spindle washers. Now there is no problem getting chucks and face plates off the spindle. Cleanliness is the answer. I am glad that I can put my pipe wrench and hammer back in the box. Thanks to all for your input. Ron

Re: Update on sticking spindle/chuck

#2

Re: Update on sticking spindle/chuck

phillip Medghalchi

Ron, I ran into the same problem today. specially with the high humidity we have down here in S. TX, anything fine like dust will creep up into the fine crevices and make things stick. I am seriously thinking of following John Jordan's advice on cleaning up first thing in the morning,waxing the bed ways, oiling and inspecting everything before you even dare to pick up the first gouge or mount something on the lathe. Or, at the least possible, once a week on certain day should be tool maintenance day, and no matter how pretty of a day and beautiful weather it is, should still be the day for tool maintenance. I know it's tempting to pick up the tool and go through the exhilarating sense of making shavings, but I think at the end of the day you have a nicer turning time. Now, I have to go practiced what I just preached and report the progress. (preaching is cheap, putting it into work is for someone else) :b

Re: Update on sticking spindle/chuck

#3

Keith Tompkins

Re: Update on sticking spindle/chuck

Keith Tompkins

Which brings up the question: How many people regularly clean and maintain their lathes?

Re: Update on sticking spindle/chuck

#4

... or chucks?

Geoff Whaling

In Far North Queensland we mostly have humidity above 60% all year and near 95% for many months in the wet season. Maintenance is just part of the game. I cringe when I see turners struggling with gummed up chucks or "blunt" tools or gear that have been neglected. They will perform much better with an little TLC and often only requires a few minutes attention.

Re: Update on sticking spindle/chuck

#5

Re: Update on sticking spindle/chuck

phillip Medghalchi

Keith, my cleaning person told me we don't pay her enough to mess with it. so, i have to get into the habit of doing it myself. Now, when it becomes a routine I'll report back to you. For now, I think it is work in progress. Now, if someone was paying me for turning then they make sure the stuff we work with are clean.