Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

lathe speed drive broke

Posts

lathe speed drive broke

#1

Harry Robinette

lathe speed drive broke

Harry Robinette

The reeves drive in my General came apart while I was turning last thursday.Messed with it all day yesterday and was going to get my LARGE HAMMER when I decided I better quit. Went back at it this morning and got it fix I hope.

The sheaves came apart, so had to remove the system and redo everything Don't do this unless you absolutlly have to. The reaves drive has to be set by the sizing of the belt if one belt is to long the speed dial is off so after all the messing for two days" MY DIAL IS OFF "

But it runs and I never really used the speed dial anyway.

Now a question for the turning brain trust. The link belt I'm using is sliping on the pulleys,the regular belt holds very good no sliping at all. So now what.

The one that's sliping the most is the one at the motor.

Re: lathe speed drive broke

#2

Re: lathe speed drive broke

John Lucas

Reeves drives require a fairly frequent clean and lube to keep the moving pulley moving like it's supposed to. A pain in the butt and varies on how easy or hard it is to do it depending on the machine. At least in my experience.

I have always heard that a link belt won't work very well on a Reeves drive so I never tried it. Sounds like your experience may prove them right.

Re: lathe speed drive broke

#3

Re: lathe speed drive broke

bowlman

Link belts are not recommended for Reeves drive machines like the General lathe. The Reeves drive consists of 2 conical sections which create a floatinf "V". The link belt sides are not configured for the "V" shape but rather for a flat side.

Don't ask me how I know this, please!!!! I have a General 260 from around 1985 with the riser kit to make it into a 20 inch swing. Been turning on it daily for many hours for all those years and have lots of experience. frequent greasing is really all that is needed.

Re: lathe speed drive broke

#4

I have been using the red link.....

JamieDonaldson

....belts on my General 160 Reeves drive for many years without a problem. The links of the belt segments I have are tapered on the sides and fit the drive pulleys just fine, but certainly don't make it any more quiet!

Re: lathe speed drive broke

#5

Harry Robinette

Re: I have been using the red link.....

Harry Robinette

Thanks allot guy's. That's what I was thinking. Jamie I'm going to look and see is mine are tapered or not.

Re: lathe speed drive broke

#6

Re: I have been using the red link.....

Bill Boehme

Link belts, just like any V belt, have a V cross section because they run on the sidewalls of the pulley. Any V belt that runs on the bottom of a pulley is way beyond worn out.