Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Crack filling

Posts

Crack filling

#1

Crack filling 

phillip Medghalchi

...with CA glue, without making a mess or staining the wood.

last night I made the bowl that you will see bellow and when i went to put lacquer sanding sealer on it I noticed that two cracks opened up that I need to fill them with saw dust. Please, understand that the bowl is not completely finished and yes , I am aware that the cracks are due to turning end grains, whoever, I incorporated what was given to me from the wood into the design and turned it,t hat means that the cracks are part of the design and I went with them. My qsn. is that lately even though I put a 50/50 mixed of lacquer and the sealer on the wood as I am trying to fill the cracks or voids I still get the wood stained, which ends up with hand sanding for a long time to get he stains out, so How can I fill these cracks and finish the bowl w/o making a mess of it?

The bowl only has one coat of sealer and I applied it little at a time until I got the whole thing covered and then wiped off the excess. I still have to put two more coats of sealer and then finish with lacquer.

Any suggestions or tips are very much appreciated.


Re: Crack filling

#2

Re: Crack filling

Barry Irby

What I do is to seal the piece with lacquer or lacquer sanding sealer (as you did) and then fill the cracks with CA. I use medium CA on larger cracks, ones i might get a piece of paper in and thin CA on the very fine ones. I try not to use the accelerator because it may cause it to foam and turn white. You have to watch out for gravity. The CA will run, so have the crack UP, until it starts to cure. Once it starts to cure you can hit with a little accelerator. Then I sand the area back to the bare wood. I hit with accelerator several times along the way if I expose some less that fully cured CA. Then I apply more lacquer or sealer and see if I need more CA.

On the first coat I don't really work at keeping the lacquer out of the cracks, but I don't try to get it in them either. On side grain, you can start the CA process sooner, before you have finished turning and then turn away the CA on the surface. Does not work as well on end grain because the CA will soak a long ways into the wood. OTOH, I find CA matches lacquer pretty well and blends into the finish. Not so much with oil based finishes.