Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Cherry and Black Willow Bowls

Posts

Cherry and Black Willow Bowls

#1

Allan W

Cherry and Black Willow Bowls

Allan W



After a weeks work, this is a bowl made from Cherry. The finishing took the longest as the end grain and the bottom of the bowl kept soaking up the finish. Bowl size is 9 inches by 3 inches.



This is turned from dried Black Willow. Thanks to the new Robo Rests for the grinder, it was much easier to turn and get reasonably smooth before I had to sand. Properly sharpened gouges and scrappers really improved my work. This is also the first time I have gotten a bowls sides down to a 1/4 inch thickness. Bowl size is 7 inches by 3 inches.

Re: Cherry and Black Willow Bowls

#2

Re: Cherry and Black Willow Bowls

phillip Medghalchi

Allen, what kind of finish you put on the Cherry, that didn't cloud out on the voids and bark inclusion?

Nice job on both?

Re: Cherry and Black Willow Bowls

#3

Allan W

Re: Cherry and Black Willow Bowls

Allan W

I used a spray finish from Rust O Leum. Its Painters Touch 2X clear. The Black Willow bowl is finished with Salad Bowl wipe on finish.

Re: Cherry and Black Willow Bowls

#4

Re: End Grain Tear Out

Steve Criscenzo

Allan

As you are finding, sharp tools make life much easier. Using a guide such as the Robo Rest will make it easier to get a consistent edge every time without taking too much steel.

A couple of comments. It looks like you are still getting some end grain tear out. If your tools are sharp, then I would look at your presentation of the tool to the wood to try to minimize the tear out. There are some great videos on YouTube that show how to shear scrape with a bowl gouge. It really helps get a smooth surface and minimize sanding. Check out the John Lucas YouTube channel for some great instruction including how to shear scrape.

I also tend to prefer penetrating finishes for bowls rather than a finish that sits on the surface. It is much easier to get smooth and you do not have to worry as much about differences in adsorption rate for side and end grain.

Steve

Steve

Re: Cherry and Black Willow Bowls

#5

Lyle Jamieson

Re: End Grain Tear Out

Lyle Jamieson

I have some YouTube clips that might help too. Direction of the cut with supported grain is almost just as important as sharp tools.