Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Will acrylic and acetone penetrate punky wood?

Posts

Will acrylic and acetone penetrate punky wood?

#1

Will acrylic and acetone penetrate punky wood?

Craig Daymon

I know you can mix acrylic shavings with acetone and, typically using a vacuum chamber, it can be used to stabilize blanks. (Mostly pens, otherwise the chamber gets very costly.)

If I keep the mix thin, more acetone than acrylic, will it penetrate into a larger blank?

The particular blank is very dry and not so much punky as just very prone to tear out, with some deterioration from spalting. Though still very solid. (And lots of curl.)

Really want to get a clean surface out of this, and there is another half of this blank that I'd like to make good use of as well.

Thanks.

Re: Will acrylic and acetone penetrate punky wood?

#2

Dennis in Southern Oregon

Re: Will acrylic and acetone penetrate punky wood?

Dennis in Southern Oregon

Sounds like lab time Craig if you have a big enough scrap of the wood to work with. I haven't worked with acrylic/acetone mixture, but I assume it sets up fairly quickly. I wouldn't think you would need very deep penetration if you apply it after roughing out the piece, or perhaps repeatedly as you progress.

Dennis

Re: Will acrylic and acetone penetrate punky wood?

#3

Re: Will acrylic and acetone penetrate punky wood?

Dick Coers

There are so few solids in that kind of mixture, it will not be like vacuum stabilized. You might just try brushing on sanding sealer before making those light final cuts.

Re: Will acrylic and acetone penetrate punky wood?

#4

More concerned about your health

Geoff Whaling

I would be more concerned about the short term and potential long term affects upon your health using an acrylic & acetone solution. The volatiles can't be good for your lungs etc plus acetone is highly flammable.

"This product is classified as: Xn, Harmful. Xi, Irritating. F+, Highly Flammable. Hazardous according to the criteria of SWA."

"Highly flammable. Irritating to eyes. Repeated exposure may cause skin dryness or cracking. Vapours may cause drowsiness and dizziness."

From an Australian Material Safety Data Sheet for Acetone. Add in Acrylic in "solution" and it seems to be a mix I that I would be seeking specialist advice before contemplating using it.

Re: Will acrylic and acetone penetrate punky wood?

#5

Re: Will acrylic and acetone penetrate punky wood?

Jim H

Depending on the blank size, Cactus juice ( TurnTex.com) is the way to go. It is heat cured so 100% turns solid when cured. At $90 a galon I would rough turn first so that you don't turn away a lot of the stabilized material.

You will need a vacuum chamber, but that's easy to do with a stout pot and a sheet of acrylic. The harder part is a outside oven to cure the blank. I use a large toaster oven.

Re: Will acrylic and acetone penetrate punky wood?

#6

I frequently stabilize punky wood with......

JamieDonaldson

....lacquer diluted with about 10% acetone. Its easily absorbed, dries quickly, and doesn't interfere with the final finish which is often more lacquer.

Re: Will acrylic and acetone penetrate punky wood?

#7

Ditto but I thin the lacquer 50/50