Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Party Time -Big chip & dip bowl

Posts

Party Time -Big chip & dip bowl

#1

Party Time -Big chip & dip bowl

Roger Chandler

Party Time! - Big Chip & Dip Bowl!

This has just a little more finish work to be done on it, but that will have to come in a day or so after the Mahoney's Walnut oil is cured out a bit.

This is ambrosia maple..........just a hair under 18 inches wide and 4.5" to the top of the inner bowl rim. Flared out rim on the chip bowl and on the dip bowl for symmetry. This one required soooooooo much sanding........! Several hand and power sanding sequences and then a full sequence of wet sanding with the walnut oil to bring it to this state.......tear out on the punky areas was not fun.........but I used shellac and all other tricks in my arsenal, but finally got it about right............except now that it is dry, I see something in the very center of the dip bowl and area that did not show up when wet..........it will get a little touch up, for sure!

I made this one deep enough to pile the chip and dip onto it.........after all, if you're going to have a party, do it big! I kinda like the curl and the ambrosia features........notice the limb pocket in the bottom as well.....lots of character on this! I purposefully made a wide base for its stability...........it looks better in person than the pics show IMO........I think it will make a nice center piece for a table setting on party day!



Re: Party Time -Big chip & dip bowl

#2

Re: Party Time -Big chip & dip bowl

Barry Irby

That's a beauty. I made several of these but mine were about 12" in diameter. they were a hit and I am sure yours will be too.

A suggestion....I bought a Pyrex dish with a snap on lid and used it as a liner for the dip bowl. Actually bought several for each one so the host or hostess could make the dip in advance and have spares waiting for the hungry. Make the "receiver" a little loose so that if it shrinks or warps the liners will still fit. Or twice turn it. Or both.

Re: Party Time -Big chip & dip bowl

#3

Nice work, Roger.

GaryG in MD

I can imagine all the time you've put into it to get it to this stage. ...GG

Re: Party Time -Big chip & dip bowl

#4

Re: Nice work, Roger.

Roger Chandler

Thanks Gary! Lots of time indeed.......just the nature of this particular piece of wood........

Re: Party Time -Big chip & dip bowl

#5

Great Job!

Don Orr

Let us know when the party is. :D ;)