Not turning, but mind-blowing *LINK*
steven antonucci
Watch the 2 minute video. Seriously.
Mind. Blown.
Knowledge You Can Build On — Est. 1998
Not turning, but mind-blowing *LINK*
steven antonucci
Watch the 2 minute video. Seriously.
Mind. Blown.
Re: Not turning, but mind-blowing
Lan Brady
worth sharing. Thanks
That is a seriously sharp plane blade
A properly sharpened and tuned Japanese......
Dick Coers
hand plane will make shavings that float on the air instead of falling to the floor.
Re: Not turning, but mind-blowing
phillip Medghalchi
Steven, thanks for sharing. In Iran they have the same thing that they use on decorative boxes, and for most part in middle east and far east like India and Indonesia, have the same thing. I wonder if this art came form Japan and spread over that region. I have few pieces of them in my house that I marveled as how they have done it. I Tell you what they are not cheap when you go guying one of those pieces and specially if they used ivory in it then you pay a very good price for them. I add some pic.s for you to see. One thing I noticed that they are very delicate and in my pieces because of the temp. and relative humidity changes in my area they came undone and glue separated. Then again they must not have been the best quality work just like everything else. '
But when you see them up close you think that how many hours go into one of those boxes?
Re: Not turning, but mind-blowing
Josh Bowman
Steven, He can't be much of a woodworker, were's the PM66, 16" bandsaw, etc.? 
Seriously though, folks like that remind and humble me I'm really just a tool collector, not a craftsman.
nice to see
Re: nice to see
Dick Hines
If I sat with my legs crossed like that guy for as long as he does some one had better there to help me up. Even then my legs may never be right again.
He does do great work with very simple tools.
I was looking for a maker's brand on that plane,
Keith Newton
Was that a Stanley, or Greenley? Those are my favorite brands for work like that. ha
I was wondering, does that get me shot on this forum? It would probably mean burning at the stake over on the hand-tool forum. he he
I think we should do it with a skew
I bet there is no sanding on them :-)