Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Mark Sfirri - Greatest turner ever...today

Posts

Mark Sfirri - Greatest turner ever...today

#1

Mark Sfirri - Greatest turner ever...today

Craig Daymon

I've been working on an eccentric turned base/stem for a mirror. I've done some eccentric turning before and maybe it's because this one has a bit more mass (add to that a poorly lit shop and a very tight turning area), but I am more and more impressed with the work Mark has done. That large, maybe 8 foot baseball bat that hangs in the BCCC shop would have terrified me. I wonder if he set up any safety shielding when doing it?

I've switched to using a curved toolrest to better get in to where I'm tryng to cut and minimze the overhang. Still, I have to say this feels like work.

Here's a pic of the work in progress. It started out as a piece of Mahogany, about 3"x6"x10".


Re: Mark Sfirri - Greatest turner ever...today

#2

Re: Mark Sfirri - Greatest turner ever...today

John Lucas

Looks like fun. YOu do have a dangerous week point on the end grain where the tailstock is. When I do things like that I add an extra board on the bottom that has the long grain running down to it. This would prevent the weak end grain from breaking. I will often also make the support board as large as the overhang so it helps counter balance the weight and keeps the vibration down. Something like a round disc with a wedge hot glued under the end of the turning. Then if needed screw some weights to the disc to counterbalance offset turning.

I did a sort of Y shaped turning with on leg of the Y missing. Not truely offset several times like your turning. I cut the long curve on the bandsaw and then glued the upper Y portion to a disc. So for turning purposes it was off balance just like yours. I later carved the inside of the curve. I know it's hard to visualize but lets say it was off center the same as whats in your photo.

Re: Mark Sfirri - Greatest turner ever...today

#3

Meant to say that I agree with you about Mark.   


Re: Mark Sfirri - Greatest turner ever...today

#4

Re: Mark Sfirri - Greatest turner ever...today

Craig Daymon

Yeah, I realize those weak points exist, but it feels pretty solid and I check it frequently. (Though, it's probably likely to just give all at once, if at all.) A piece of plywood on both ends probably would have been the better way to do it, glued down and screwed in at least on the thicker ends. It's far enough past that point now that I'll chance it.

The use of the curved toolrest was a real help.

It's funny to read Barbara Dill's articles on multi-axis turning. She comments that she cranks it up to 3000RPM. I understand that it will make it respond more lke solid wood, but there isn't a chance I can do that here.

Re: Mark Sfirri - Greatest turner ever...today

#5

Re: Mark Sfirri - Greatest turner ever...today

John Lucas

yea Barbara's aren't as far off center as yours. Smaller spindles are obviously much safer.

Re: Mark Sfirri - Greatest turner ever...today

#6

Re: Mark Sfirri - Greatest turner ever...today

Craig Daymon

Yeah, I'd love to see a video of Mark turning that large bat. It's one of his where there is a notch turned out of it, with opposing bead, that looks like it might have been caused by a ball, so it's probably only off center by less than what my current turning is at its max, but at what I'm pretty sure was 8 feet of bat, that would still be something to see.

Re: Mark Sfirri - Greatest turner ever...today

#7

George Balock

Re: Mark Sfirri - Greatest turner ever...today

George Balock

Craig,

Just crank it up and make sure the life insurance premium is paid😄