Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

a motor for my next lathe *LINK*

Posts

a motor for my next lathe *LINK*

#1

a motor for my next lathe *LINK*

John Lucas

I think I would need a spindle of at least 2" and probably without a morse taper so it would be stronger. Lathe would need to weigh in at a ton or more. My friend Joe Looper had the lathe which had a 54" swing and can't even guess at the weight. He had a 5 horse motor on his.


http://www.golsn.com/listings/equipment-tools/tools-parts/3573153.html

Re: a motor for my next lathe *LINK*

#2

Mike Stafford

Get a real motor....

Mike Stafford

When I replaced my motor I decided to get a big one, a real big one. :D

Here is a picture of it being delivered to my shop. The only thing that limits my swing is the ceiling and the earth.


Re: a motor for my next lathe *LINK*

#3

Re: Get a real motor....

Dale Miner

Mike,

You do know that it is a rope start motor don't you?

Re: a motor for my next lathe *LINK*

#4

Dick Hines

Re: Get a real motor....

Dick Hines

John, I hope you and Mike never get a catch. You will be headed for the moon.

Re: a motor for my next lathe *LINK*

#5

Mike Stafford

That's funny Dick, real funny!


Re: a motor for my next lathe *LINK*

#6

Bill Blasic

Re: That's funny Dick, real funny!

Bill Blasic

Mike,

Your humor is only surpassed by your imagination :D

Bill

Re: a motor for my next lathe *LINK*

#7

Re: a motor for my next lathe

Ed in Leaside

Unfortunately I've only enough power in the shop for a motor half that size. :(

Re: a motor for my next lathe *LINK*

#8

NASA needs help. We can work out a deal 


Re: a motor for my next lathe *LINK*

#9

Don Leydens

Re: a motor for my next lathe

Don Leydens

You're too late, Mike. I think Terry had this delivered to his shop to hook it up to a dust collector to help clean up his shop. Notice I said "help".

Re: a motor for my next lathe *LINK*

#10

Ellis Walentine

We turned the world's largest bowl...

Ellis Walentine

... on a Highlander lathe from Scotland during our American Woodworker Shows in 1997. I can't recall exactly, but I'd say the swing was around 10' -- actually, I think they were prepared to outfit it with a riser kit should you need additional capacity. Our bowl finished out at 7' - 9 1/2" OD. The ring tools we used were 7' long with shanks around 1 1/4" as I recall, maybe heavier. We started the blank at about 3 rpm and got it up to maybe 30 at the end of the process.

I'd definitely say that a Morse taper wouldn't be necessary if you need a lathe that big. We used a 24" faceplate on the headstock and a 16" faceplate on the tailstock.

Let us know what you decide to do.

Ellis